Enter your screen's mesh count and get a film LPI, a starting dot range, a screen angle and a film resolution. It uses the common rule of mesh divided by 4.5, the same rule the Halftoned studio uses when you pick a mesh.


How it works
- Film LPI is the mesh count divided by 4.5, rounded, and kept between 20 and 120 LPI. The usual advice is mesh divided by 4 to 5; 4.5 sits in the middle. The LPI for your mesh guide explains what goes wrong either side of it.
- Dot range is the smallest and largest dot the screen can be expected to hold: 5% to 92% below 180 mesh, 3% to 95% from 180 up. Coarse mesh has a harder time holding a tiny highlight dot open and keeping a heavy shadow dot from bridging. It is a starting point; find your printable dot range with a step wedge and use what your own screens hold.
- Angle is 22.5°, which keeps the dot grid off the mesh weave. 0° and 90° line the dots up with the threads and cause mesh moiré. For several colors, see halftone angles and moiré.
- Film resolution is 720 dpi, or 1440 dpi above 85 LPI. 360 dpi is enough at 55 LPI and below.
To turn a picture into a one-color film at these settings, use the free halftone generator: pick the same mesh and it sets the same LPI, dot range and angle.
When to go off the number
- Simulated process on dark shirts usually runs 45 to 55 LPI on mesh that can hold it. See simulated process on dark shirts.
- Index separations have no LPI. The dots are a fixed size set in dots per inch: 180 dpi suits 230 to 305 mesh. See index color separations.
- Thick or specialty inks (puff, high density, glitter) need coarse mesh, and so a coarse halftone, or none at all.
In Halftoned
Pick the mesh you own and the ruling, minimum dot and maximum dot follow, then the proof shows the real dots before you burn a screen. $15 a month or $150 a year, unlimited films. See the pricing or the preview.
Questions
What LPI should I use for 156 mesh?
About 35 LPI: 156 divided by 4.5 is 34.7, rounded to 35. Start with a dot range of 5% to 92% and a 22.5° angle, then adjust from what your screens hold.
What LPI should I use for 230 mesh?
About 51 LPI, with a starting dot range of 3% to 95%. That is also inside the 45 to 55 LPI window most simulated process work uses on dark shirts.
Why divide the mesh count by 4.5?
Each halftone dot has to sit on enough mesh threads to stay open in the highlights and not bridge in the shadows. A ruling of about a quarter to a fifth of the mesh count gives each dot room on the threads; 4.5 is the middle of that range.
What film resolution should I print at?
720 dpi gives crisp dot edges for most work. Go to 1440 dpi for fine type and rulings over 85 LPI; 360 dpi is enough at 55 LPI and below.