Hold the film up to a light. If you can see light through the black, the film is not dense enough, and no exposure time will save the screen. UV gets through the thin black, hardens emulsion that should have washed out, and the stencil fills in or breaks down. Fix the film first.

Why exposure cannot fix a thin film
A good film blocks UV completely where it is black and lets it through where it is clear. A thin film only slows the light down. Expose long enough to harden the open areas and the light starts hardening the image too. Expose short enough to keep the image open and the stencil is underexposed and weak. There is no good time in between.
Fix it in this order
- Choose the heaviest media setting. Pick the film, transparency or heaviest photo paper setting the driver offers. It decides how much ink the printer lays down.
- Turn color management off. You are printing a black separation, not a photograph. Any color management in the driver lightens the solids.
- Raise the color density. This is the setting most often missed. Start from the printer maker's own recipe if it has one.
- Try black-only and color mode. Print the same solid bar both ways and keep whichever blocks more light. Which one wins depends on the printer and ink, so test rather than assume.
- Change the film. A film stock made for inkjet positives holds more ink than a generic transparency.
- Double strike, as a last resort. Printing the film twice, or stacking two films, adds density but costs registration and sharpness.
Epson's own film recipes
Epson publishes film-positive settings for three of the printers shops use most (its screen-printing guide, PI-EH102):
| Printer | Epson's film recipe |
|---|---|
| SureColor P900 | Color Density +50, Mode: Off (No Color Adjustment) |
| SureColor P5370 | Color Density +25, Mode: Off (No Color Adjustment) |
| SureColor T3770 | Print Mode: Black, Color Density (Black) +15 |
Dye-based printers are the hardest case. Run a density test before you commit a job to one. The printers for film positives list has each maker's film settings by model, and can a browser film RIP print dark film explains which part of the chain decides the black.
Rule out the other causes
If the film looks dense and the screen still fails:
- The film is not tight to the glass. Light creeps under a loose film and softens the edges of the image.
- Light leaks. Tape over part of a coated screen and leave it in your darkroom. If that part washes out differently from the rest, light is getting in.
- Overexposure. Even a good film leaks a little UV. A wildly long exposure can burn through it.
Then test the exposure
Once the film blocks light, burn an exposure test: the same film at several times, for example half, 0.7×, your usual time, 1.4× and double. Pick the time where the finest dots and reversed lines are still open and the solid is fully hardened. Write down the driver settings and the time. You will want them in six months. See find your printable dot range.
In Halftoned
The Calibration page prints a density bar and an exposure test film, turns your usual time into a schedule of five exposures, and saves the result for each printer and film stock. The Epson recipes above are on those printers' entries. See how to print film positives on an inkjet, the preview or the pricing.